Dual Flush Water Conservation Kit

SelectAFlush is a dual flush toilet kit and a water conservation device for standard toilets. Saving water could never be easier. The kit will convert your toilet into a dual flush enhancing the performance of your current toilet for a fraction of the price of a new dual flush toilet. No plungers here!

SelectAFlush dual flush retrofits current toilets to perform like low flow toilets and in some cases saves more water than a high priced HET toilet. No need to buy a new toilet and send your old toilet to the dump, just convert your current toilet into a water saving dual flush. SelectAFlush was developed by a LEED Accredited Professional (LEED APs) to give the most optimum water savings yet still have the ability to recycle your old toilet. By converting your old toilet to save water, you are also saving our landfills.

SelectAFlush easily installs in minutes using highly engineered, long lasting seals that will not leak. Now you can save water on all standard two piece toilets designed for a 2 flush valve. Simply replace any flapper flush valve with SelectAFlush and start reducing your water consumption immediately. Imagine saving thousands of gallons of water per year without sacrificing convenience or performance. Our product can save more water than a low- flow toilet when installed on a 3.5 gallon toilet or smaller.

Our retro fit flush valve will save over 7 million gallons per year per 1000 installations on 3.5 gallon toilets. BE ONE IN A THOUSAND or better yet, BE ONE IN A MILLION. A little flush goes along way.

Order the Dual Flush Kit Today and Start Saving
$32.95 ea

Click here for Installation Instructions

SelectAFlush dual flush conversion kits fit over 80% of all existing two piece residential style toilets. It will save water in 1.6 gallon and larger toilets with left and right hand front facing levers. It will NOT fit on toilets with handles on the SIDE or CORNER of the tank at this time. We also require 7/8" clearance from the edge of the tank to the edge of the currently installed flush valve.

Installation Requirements

Define your handle position

Check your measurements

All measurements are taken from the inside of tank
(7/8" or larger clearance is required between the edge of the drain hole and the edge of the tank)
Tank must fit a standard 2-1/4" flapper valve (fig 1) meaning the diameter of the drain hole in the tank is 2-1/2" wide (fig 2)
A minimum of 11-3/4" height clearance is requires from base to top of tank. NOTE: Most tank lids have some extra height clearance to allow for fill valve.
1-3/8" or more clearance is needed from side of tank to the center of the flush lever hole.

	Welcome to Oodles Of Parts Plus	Solution Provider...